![]() I hope with this technique to get sharp corners always. Taller K unexpectedly has vertical sides. As seen, the pieces do not align properly, because of rounded corners I think, but I cannot see through the pieces. It was unsuccessful and produced vertical sides in my second attempt. For the female piece, I set start depth to 0 and max toolpath depth to 0. I have attached some Estlcam project files, g-code files, and svg file on which I base my design. Now I want to go further, and fill the pockets with wood instead of paint. I do not believe the problem is with the machine, but in my use of the Estlcam software. ![]() ![]() Perhaps this should go in Troubleshooting, I am not sure.
0 Comments
Leave a Reply. |